The 0.02 class calibrated resistors excel in their modern design and small mechanical dimensions. Their ruggedness also ensures a long life.

	when normal resistors prove to be too large
	to test measuring bridges
	for tests on electrical temperature measuring equipment
	for laboratory setup of a Wheatstone bridge
	to setup plate circuits
	for a defined current characteristic at a defined voltage
	as shunt resistor for current measurement
	as part of standard equipment in research laboratories
	for a large part of measurements in calibration workshop.

With the delivery of this calibration resistor you get a test certificate corresponding ISO 9000 with detailed technical data.

DKD Calibration Certificate

burster präzisionsmeßtechnik at Gernsbach have set up a calibration centre for electrical quantities, connected to the German Calibration Service (DKD). This calibration centre is supervised by the Physikalisch-Technische-Bundesanstalt (PTB) at Braunschweig and is entitled to issue calibration certificates. The measurement results and uncertainties contained in the calibration certificate are obtained by using standards and measurement instruments subject to regular comparison with state standards of the Federal Rebuplic of Germany and are therefore constant with these. The proof of state control exists in the form of the calibration certificate itself and in a calibration mark which is put on the test piece. The resistor described can be supplied with a DKD Calibration Certificate.

Manufacturer Calibration Certificate

Please refer to DKD Calibration Certificate but with reduced accuracy.
The traceability of the used secondary voltage and resistance standards to the national standards according to DIN ISO 9000ff is guaranteed by our certified calibration laboratory
(DKD-02101)