 |
||
 |
 |
 |
 |
||
 |
 |
|
 |
||||||
|
The new modular amplifier for strain gauge and potentiometric sensors continues the success of its predecessor. Unchanged is the easy DIN-ray mounting, - snap up and ready. Dip switches allow an easy tuning of the zero point, gain, sensor supply voltage and maximum frequency response. Fine tuning is done via the front panel. The built-in precision voltage source offers a very handy calibration help by simply simulating the sensor signal at the sensor input. Simultaneously output signals of + 5V, + 10V or 0-20 mA (or switched to 4-20 mA ) are available. Ground - loops which are much feared for their wrong measuring results are eliminated through electrical insulation of the measuring part from the power supply. Additional power supply modules are available for cases where a 20-30 volts supply is not available.
|
|||||||||
