8511 Load bending beam

Highly accurate, very low mounting height, simple force introduction, for tension and compression, for static and dynamic measurement, material aluminium resp. stainless steel, protection class IP 64

  • Features

    • For tension and compression forces
    • Measuring ranges from 0 ... 5 N to 0 ... 2 kN
    • High linearity up to 0.1 %
    • Very low mounting height
    • Simple force application
    • Material aluminium or stainless steel
    • Special design on request
  • Product data

    Model 8511
    Measuring range

    0 … 5 N
    0 … 10 N
    0 … 20 N
    0 … 50 N
    0 … 100 N
    0 … 200 N
    0 … 500 N
    0 … 1000 N
    0 … 2000 N

    Direction of force Tension and compression
    Standardization Option
    Signal output

    1 mV/V
    1.5 mV/V
    depending on measuring range

    Protection class IP54
    Overload protection Option
    Range of operating temperature -30 ... +90 °C
    Specific characteristics
    • High linearity up to 0.1 %
    • Very low mounting height
    • Simple force application
    • Material aluminium or stainless steel
    • Special design on request
  • Description

    Model 8511 bending beam load cells are designed for measuring tension and compression forces. Their high accuracy, low torque sensitivity and very low mounting height make these sensors particularly suitable for use in weighing and dosing technology as well as for laboratory and production use.

    Extremely simple force application makes the sensor easy to handle. It offers a very favorable price/performance ratio and can be used universally for static and dynamic measurements.

    Examples of application:

    • Dosing system
    • Load deflection curve
    • Tension force measurement for wire or thread winders
    • Friction forces
    • Cable force
    • Withdrawal force, etc

    The measuring element of this load cell consists of a double bending beam with strain gauges, the resistance of which changes with the application of force. Upon applying a voltage to the strain gauge bridge, the change in the strain gauge resistance is converted into output voltage, which is directly proportional to the force. The strain gauges and the entire measuring element are protected from water spray by rubber bellows.

    To install the load cell, it is securely clamped on the side with 2 bore holes. The tension or compression force to be measured is applied at the other end. Force is applied easily perpendicular to the sensor axis. This serves to prevent falsification of the measured values. The influence on the measuring signal resulting from the increase of load distance on the mounting side (e.g. by a touch finger) is negligible. Overload protection can be realized with little effort using a mechanical stop.

  • Data Sheet & Downloads

    Data sheet
    Brochure
    Operation manual
    Further info

Solutions

Lösungen Bild

Sectors

Chemical Industry
Machine Manufacturers
Metal / Steel Industry
Others

Product Inquiry

    Product comparison

      Amplifier module 9250
      Bus controller 9251

      • Outstanding system with up to 8 modules, expandable fieldbus interface via the bus controller
      • Supports Ethernet based fieldbuses as PROFINET, EtherCAT, EtherNet/IP or I/O interface

      Discover the universal diversity of this innovation ...

      © 2018 // burster präzisionsmesstechnik gmbh & co kg
      nach