Relative non-linearity: ≤ ±1.0 % F.S., normalized output signal 0 ... 10 V, stainless steel sensor, compact design, customer-specific versions possible from 20 pieces up
Please notice that there is a limit of 5 products for the product comparison.
Your latest selection was canceled.
×
Model | 8532 |
Measuring range |
0 … 500 N |
Direction of force | Compression |
Standardization | No |
Signal output | 2 mV/V |
Protection class | IP60 |
Overload protection | No |
Pull-plate | No |
Load introduction button | Yes |
Range of operating temperature | -20 ... +80 °C |
Specific characteristics |
|
This force measurement chain was developed for applications where a low cost solution is more important than achieving high levels of accuracy. The sensors strain gauge technology allows the measurement of static and dynamic forces. The load cell is also designed for applications that provide only little space due to its compact design. These properties, together with the sensors dust protection, make the measuring chain suitable for a wide range of applications, such as
The body of the sensor is a flat, cylindrical disk, into which a domed force application knob is integrated. It is important that the force is applied axially to the center of the sensor. The domed form, however, minimizes the effect of a force that is not exactly axial.
A full-bridge strain gauge is used as the measuring element inside the sensor, by means of which the force to be measured is converted into a proportional electrical voltage.
The in-line amplifier increases this voltage from 0 up to 10 V. The surface against which the sensor rests is important for the quality of the measurement. It should be ground. It must be sufficiently hard and thick and not deform under load
Example showing load cell fitted under pre-load with extreme overload protection
Talstr. 1-5
76593 Gernsbach
Germany
Fon: +49 7224645-0
Fax: +49 7224645-88
infoburster.com
www.burster.com
Wire
15.04. -
19.04.24 -
Düsseldorf,
40474,
Germany
The Battery Show
18.06. -
20.06.24 -
Stuttgart,
70269,
Deutschland
burster gmbh & co kg
sensors & precision measurement
Talstr. 1-5
76593 Gernsbach
GERMANY
Contact:
Phone: (+49) 07224-6450
Fax: (+49) 07224-64588
E-Mail:
infoburster.de
The measurement solution.
It‘s with this ambition and for over half a century burster, a global player in the precision measurement technology industry, supplies some of the world’s most recognizable brands with sensors, precision measuring devices and measuring systems for sensor signaling processing. This is all done through our research, development and production headquarters in Germany.
Where quality assurance and production control play a significant role, burster is on board.