Compact, flat disc design, small diameter, low overall height, completely welded body, central clearance hole, stainless steel
0 … 100 N
|Direction of force||Compression|
|Protection class||IP54 / IP65|
|Load introduction button||No|
|Range of operating temperature||0 ... +85 °C|
The force to be measured must be introduced axially and perpendicularly to the entire surface of the inner and outer bands of the sensor in the opposite direction. Conversion of the acting force into an electrical output signal is performed by strain gages connected together in a full bridge circuit.
To achieve optimal accuracy, the base of the sensor should rest on a smooth level surface, hardened to at least ≥ 58 HRC with sufficient dimensions. The base cover welded to the surface has a stabilizing effect on the sensor element. Lateral forces must be avoided anyway as they distort the measured results. Tension and bending relief for the sensor cable is to be carried out on the machine side.
Fon: +49 7224645-0
Fax: +49 7224645-88
The Battery Show
23.05. - 25.05.23 - Stuttgart, 70269, Germany