8511 Bending beam tension and compression load cell

Highly accurate, very low mounting height, simple force introduction, for tension and compression, for static and dynamic measurement, material aluminium resp. stainless steel, protection class IP 54

Product Inquiry

    Product comparison

      • Features

        • For tension and compression forces
        • Measuring ranges from 0 ... 5 N to 0 ... 2 kN
        • Relative non-linearity: ≤ ±0.1 % F.S.
        • Very low mounting height
        • Simple force application
        • Material aluminium or stainless steel
        • Special design on request
        • burster TEDS optionally available
      • Product data

        Model 8511
        Measuring range

        0 … 5 N
        0 … 10 N
        0 … 20 N
        0 … 50 N
        0 … 100 N
        0 … 200 N
        0 … 500 N
        0 … 1000 N
        0 … 2000 N

        Direction of force Tension and compression
        Standardization Option
        Signal output

        1 mV/V
        1.5 mV/V
        depending on measuring range

        Protection class IP54
        Overload protection Option
        Range of operating temperature -30 ... +90 °C
        Specific characteristics

        • High linearity up to 0.1 %
        • Very low mounting height
        • Simple force application
        • Material aluminium or stainless steel
        • Special design on request
        • burster TEDS optionally available
      • Description

        The measuring element of the load cell consists of a double bending beam on which strain gages are applied. The applied force detunes the measuring bridge so that a proportional output voltage is generated. The strain gages on the measuring element are protected against dirt and water spray by a rubber bellows.

        The sensor can be easily mounted via two mounting holes. The tension or compression force to be measured is introduced at the opposite end perpendicular to the sensor axis.

        Due to its special design, the influence by an extension (e.g. touch finger) on the measuring signal is low. Overload protection can be realized with little effort using a mechanical stop.

      • Data Sheet & Downloads

        Data sheet
        Brochure
        Operation manual
        Further info
      • Videos

        Please accept marketing-cookies to watch this video.

        Example showing tightly-packed assembly of bending-beam load cells with overload protection


        Youtube channel Burster Youtube Channel

      • Application Examples

        Tension measurement

        in paper manufacture processes




      burster in Germany

      burster praezisionsmesstechnik gmbh & co kg
      +49 7224645-0
      infoburster.com
      www.burster.com

      Company-Information Company-Information

      Germany

      burster praezisionsmesstechnik gmbh & co kg

      Talstr. 1-5
      76593 Gernsbach
      Germany

      Fon: +49 7224645-0
      Fax: +49 7224645-88
      infoburster.com
      www.burster.com

      Trade fairs

      Wire
      15.04. - 19.04.24 - Düsseldorf, 40474, Germany  

      The Battery Show
      18.06. - 20.06.24 - Stuttgart, 70269, Deutschland  

      ×
      © 2024 // burster präzisionsmesstechnik gmbh & co kg
      nach oben