Non-rotating tightening-torque measurement

on electric screwdrivers

  • Extremly low profile
  • Bending moments have little impact on measurement quality
  • Standard square shaft
  • Excellent value for money
  • Suitable for use in harsh conditions thanks to ultra-rugged sensor design

Task

In a simple test station for electric screwdrivers, an 8632 nonrotating torque sensor is used to measure the screw tightening torque M4 to M6 screw connections.

Specific requirement

Einfache Integration des Sensors in manuellen Prüfplatz. 

Solutions

This is done by embedding the torque sensor in a C-section mount: the external square shaft is inserted into the base plate and held so it cannot rotate, while the sensor body is fixed and aligned in the C-section itself. The various screw sizes are screwed into specially made fixtures, and the maximum tightening torque is measured. The aim is to optimize the torque set in the electric screwdriver to avoid overtightening screws, to optimize downtimes, etc. 

Go to product 8630

Sectors

burster in Germany

burster praezisionsmesstechnik gmbh & co kg
+49 7224645-0
infoburster.com
www.burster.com

Company-Information Company-Information

Germany

burster praezisionsmesstechnik gmbh & co kg

Talstr. 1-5
76593 Gernsbach
Germany

Fon: +49 7224645-0
Fax: +49 7224645-88
infoburster.com
www.burster.com

Trade fairs

Wire
15.04. - 19.04.24 - Düsseldorf, 40474, Germany  

The Battery Show
18.06. - 20.06.24 - Stuttgart, 70269, Deutschland  

×

Product Inquiry

    Product comparison

      © 2024 // burster präzisionsmesstechnik gmbh & co kg
      nach oben