Relative non-linearity: ≤ ±1.0 % F.S., normalized output signal 0 ... 10 V, stainless steel sensor, compact design, customer-specific versions possible from 20 pieces up
0 … 500 N
|Direction of force||Compression|
|Signal output||2 mV/V|
|Load introduction button||Yes|
|Range of operating temperature||-20 ... +80 °C|
This force measurement chain was developed for applications where a low cost solution is more important than achieving high levels of accuracy. The sensors strain gauge technology allows the measurement of static and dynamic forces. The load cell is also designed for applications that provide only little space due to its compact design. These properties, together with the sensors dust protection, make the measuring chain suitable for a wide range of applications, such as
The body of the sensor is a flat, cylindrical disk, into which a domed force application knob is integrated. It is important that the force is applied axially to the center of the sensor. The domed form, however, minimizes the effect of a force that is not exactly axial.
A full-bridge strain gauge is used as the measuring element inside the sensor, by means of which the force to be measured is converted into a proportional electrical voltage.
The in-line amplifier increases this voltage from 0 up to 10 V. The surface against which the sensor rests is important for the quality of the measurement. It should be ground. It must be sufficiently hard and thick and not deform under load
Example showing load cell fitted under pre-load with extreme overload protection
Fon: +49 7224645-0
Fax: +49 7224645-88